Langfang Dehou Wood Industry Co., Ltd.
Product category

fair faced phenolic plywood

3 × 6 ft · 915 × 1830 mm4 × 8 ft · 1220 × 2440 mm 12 / 14 / 15 / 17 / 18 mmWBP and phenolic glueCustom sizes on request
01 Smooth Face Shuttering Plywood for Concrete
Smooth face shuttering plywood gives wet concrete a flat, even contact surface, so walls, columns and slabs come out with fewer marks and less patching. Panels cut and drill on site, take standard release agents and stay serviceable across pours.
02 Exposed Concrete Forming Plywood
Exposed concrete forming plywood is cut to your panel layout, so joint lines and tie-hole spacing land as drawn on visible concrete. Even contact faces and consistent sheet dimensions keep those lines running true across a wall.
03 Plywood for Decorative Exposed Architectural Concrete
Decorative concrete plywood carries the surface texture you choose into the finished concrete, so facades and feature walls read as designed. Contact faces are confirmed on a mock-up cast before the main pour, and panel condition stays consistent between casting areas.
04 Smooth Finish Plywood for Concrete Shuttering
Smooth finish plywood is a shuttering panel for concrete seen from below or left on show: soffits, cast counters, landscape details. The contact face inspects clean before each pour, and sheets cut down for small moulds without losing the face.
Sizes and specification

Standard panel build.

Sheet sizes 1220 × 2440 mm · 1830 × 915 mm
Thickness 12 / 14 / 15 / 17 / 18 mm
Plies 7–10 (4 × 8 ft) · 7–11 (3 × 6 ft)
Length, width, diagonal ± 3 mm
Thickness tolerance ± 0.3 mm at 12 mm · ± 0.5 mm at 15 and 18 mm
Warpage ≤ 1 %
Moisture after pressing 6 – 10 %
Measured, not promised

Performance on the label.

Control minimums versus a measured 18 mm phenolic film-faced panel. Batch certificates are available on request.

1.72 MPa
Glue shear strength
min 0.70 · +146 %
36 MPa
Static bending strength
min 24 · +50 %
5 017
Elastic modulus, MPa
min 5 000 · at minimum
9 %
Moisture content
band 6–14 · mid-band
0.04
Surface wear, g/100r
limit 0.08 · 2× under
Selection guide

Which panel fits your pour?

Send the application, cycle count and destination port. We reply with the recommended thickness, a price and a lead time.

Concrete

High-rise and residential

Slab and wall formwork for towers and housing. We typically recommend 15–18 mm phenolic film-faced panels with WBP glue for a high reuse count.

Civil works

Bridges and heavy structures

Higher loads and more casting cycles. Step up the thickness, seal the edges, and let us match the panel to your cycle count.

Interiors

Furniture and fit-out

Commercial plywood, blockboard and melamine eco board for joinery, wardrobes and OEM furniture production.

Start a conversation

Get a quotation with price, lead time and recommended thickness.

Mill-direct · English reply · Quotation in one email